COLOR PARKING LOTS for RETAIL, HOTELS, TOWNS

Applications:  From blocked off streets with sidewalk cafes,  to Hotel entryways,  to Store fronts,  to Schools, Colleges,  to side roads, to outlets, to town wide makeovers,  basketball/tennis courts,  brew pub verandas,  to courtyards,  paved paths and walkways, ....where you use the product is up to you.

Application of this product is as easy as painting.  Any employee can do the job.  No need to hire externally if you do not want.  The product spreads easily and goes on using a common squeegee.  A block of asphalt can be coated in 1 day.  

The cost is far below what you would expect,  and the overall look is comparable to brick pavers.   

Bottom line,  it's a simple job, with results that are very rewarding.    

REVIEW all the INSTRUCTIONAL VIDEOS and content within this site for a professional application of the product:

SEE PARKING LOT SEAL INTRUCTIONS and all content contained with this site:  

If product is not available to order in your area that is due to nighttime temperatures. Product may not cure and/or track in late Fall and early Spring applications). Latex-ite 55Gal. Color Grade Blacktop Driveway Filler/Sealer in Brick Red is the first tinted sealant for blacktop. Color grade is a ready-to-use, low VOC, water based sealer designed to beautify and protect your blacktop driveway with color. Color grade is a durable, tinted filler or sealer that resists hot tire pick-up, chemicals and leaves a non-skid finish. For use on exterior blacktop only (previously sealed or unsealed). Not for use on concrete. Not for use on commercial parking lots. Check the weather and make sure no rain is forecast and it is at least 55°F at night (a cold driveway will not allow the sealer to cure properly and may track).

California residents: see   Proposition 65 information 

• Approximately 400 sq. ft. to 500 sq. ft. coverage for good condition, smooth or previously sealed blacktop
• Approximately 300 sq. ft. to 400 sq. ft. coverage for moderate condition, minor cracking or graying blacktop
• Approximately 200 sq. ft. to 300 sq. ft. coverage for poor condition, rough or unsealed blacktop
• Coverage will vary based on blacktop condition
• 2 Coats (maximum) must be applied to achieve color uniformity completing each coat in one continuous application to prevent color shading
• Apply with squeegee (no rollers) - brushes are fine for the edges
• Remember: clean your driveway thoroughly so sealer will bond and make sure you do not seal when it is cold outside, it must be at least 55° at night for sealer to properly cure and last
• Do not seal in early spring or late fall as the sealer will not last; it will not cure properly and may track
• Ideal for sealing hairline cracks in blacktop driveways and walkways with color
• Durable, low VOC formula
• Car traffic ready 24 hours minimum, longer dry time recommended in higher humidity or cooler temperatures
• Wait at least 30-days before rinsing or cleaning, use a mild detergent as needed, areas that have scuffed can be cleaned with soap, water and brush after 30-days, use only a mild or diluted soap or detergent, the use of pressure washers and abrasive cleaners should be limited to avoid sealer failure
• An annual touch-up may be required in some areas subject to frequent tire traffic
• Product may look orange in pail but will dry brick red
• We recommend you continuously mix or ‘batch’ product during application for color uniformity
• Color streaks will fade once fully cured
• Color grade will not work on stamped asphalt
• For large jobs it’s a good idea to use a new 30 gallon trash can, open and pour in 4 or 5 pails and using a mud flap and drill, mix as this will help you achieve consistent color